Ref: P35-40

Includes screw on rail connecting piece, screw

Aluminum solar system central pressor connection between solar panels valid for panles with thickness of 35> 40mm

Ref: P35-40

Includes screw on rail connecting piece, screw

Aluminum solar system end pressor connection between solar panels valid for panles with thickness of 35> 40mm

Ref: IKL

Union between Rail R2 or R13 to triangles formed for flat roofs or for placement on coplanar sloped roofs.

It includes a screw on the rail connection piece, a self-tapping screw made of 316 A270 steel and insulation.

Ref: U

Union between Rails R4

It includes a screw on the rail connection piece, a self-tapping screw made of 316 A270 steel and insulation.

Ref.: UI-IK-H01P

Fastening system for tiles and concrete with fastening plate.

304 stainless steel material.

Ref: 13538

Anodized aluminum multifunction profile valid for incorporation in flat and coplanar roofs using a presser inlet system at any point of the profile without the need to go to the ends.

Profile Placement Options both on the triangle collations and on the roofs.

OPTION WITH TRIANGLES, Placing the profile horizontally (Option H recommended since it exerts more resistance, leaving the flat lower part attached to the angle and the upper part to the panel using 63mm in length in both, the only drawback the installer must drill the anchoring area where match the triangle) Quicker and easier V option when installing, but less safe for excessive wind speeds, you only have to present the Rail to the incorporated part of the triangle and it would be ready using the less wide part of 26mm.) NOTE : This option is recommended in coplanar ceilings to leave the maximum possible height between panel and cover for condensation.

Ref.: 15975.

Alloy 6005-T6 907G/m 336.2mmH 76.3mm-CC.

Special Perfil System for placement in coplanar ceilings in trapezoidal sheets, sandwich for direct drilling of the profile to the roof without using L.

4700mm bars.

Ref:. 15973

Alloy 6005-T6 980G/m Bars 4700mm length

Anodized aluminum multifunction profile valid for incorporation into flat and coplanar ceilings using a pressor entry system at any point of the profile without the need to go to extremes.

Profile Placement Options both in the collations to the triangle and in the covers.

This option is recommended in coplanar ceilings to leave the maximum possible height between panel and cover for condensation.

1 Triángulo de  800x1800x480mm.

  Triangle bracket Anodized aluminum 40x40x4mm Complete kit with screws.

Valid for 1.65x1m or 2x1 modules for horizontal placement

A separation of between 2 meters maximum is recommended.

1 1700x1600x880mm triangle.

  Triangle bracket Anodized aluminum 40x40x4mm Complete kit with screws.

Valid for 2x1m modules for vertical placement

A separation of between 1.8 meters maximum is recommended.